996 HandBrake Handle Replacement
#1
996 HandBrake Handle Replacement
All,
I was working on replacing the console of my 996. I put handbrake back in place, locked down 3 of the 4 bolts then lifted the handle to tighten the bolt under the handle. Well, apparently I don't know my own strength and actually broke the frame of the handle as I lifted it. I have the carbon fiber handle but bought a leather based one as a replacement. Is there a way to swap the handles? It looks like there is one major pin/connector (pictured) but I can't tell if this is compression fit or screw in. Has anyone done this and if so how did you do it?
I was working on replacing the console of my 996. I put handbrake back in place, locked down 3 of the 4 bolts then lifted the handle to tighten the bolt under the handle. Well, apparently I don't know my own strength and actually broke the frame of the handle as I lifted it. I have the carbon fiber handle but bought a leather based one as a replacement. Is there a way to swap the handles? It looks like there is one major pin/connector (pictured) but I can't tell if this is compression fit or screw in. Has anyone done this and if so how did you do it?
Thread
Thread Starter
Forum
Replies
Last Post
PelicanParts.com
996 Vendor Classifieds
0
08-20-2015 02:41 PM
PelicanParts.com
996 Turbo Vendor Classifieds
0
08-20-2015 02:40 PM
PelicanParts.com
GT3/GT2/GT Vendor Classifieds
0
08-20-2015 02:37 PM