Guys, trying to find answer to question from title.
I decide to use gt3 rs 2010 bonnet with the wing
so need to be sure that my airbox will be clouse proparly.
I know that fan is in different poistion.

 

I decide to check by my own.....here is the answer.

 

and...

 

Nice work. Your car is amazing. How many hours do you have invested into your car mods and whats the cost so far?

 

Thank you !
definitely much to much !
and it's not end.....

 

So it did fitt perfect..?..i have the same airbox and same rear hatch

 

you have to change the small piece bellow rear window, you have to also use the small shock when bonnet is open.
you have to use different fan, I have spal.
rest is perfect :-)

 

Your car is one of the best (if not the best) i have ever seen

 

Do your IC's have the proper airflow with that rear GT3 bumper cover? I would not think so, there is no area to draft out? What was done with the lower plastic IC vent?

Looks good though...

 

My rear hatch arrived today with the small pice below the window

I use no fan, no small shock, i use hood pins

 

He have Water ic

 

What brand are your rear hatch orginal or replica, what did it cost..?

 

original porsche part, 10k euros plus 620euros for this part bellow window.

Regarding to my latest version of coolers I found out that intake temp is dropping down when hard accelerate over 180km/h during gear change which takes about 0,4 sec.
temp is dropping just for a moment and later stays at same level and than start to rise a bit.
I did acceleration 0-300 at ambient 2C my intake was never higher than 19C during full acceleration, temperature is dropping dramatically when foot of gas pedal.
so I can say finally I have finished my intercoolers after 2 years