My gt3076's so far
#16
All my performance parts come from Protomotive.
My setup is probably a bit "oversized" for my turbos: I bolted the "best" replacement every time I had a failure. (rods, sleeves, P0021...)
My setup is probably a bit "oversized" for my turbos: I bolted the "best" replacement every time I had a failure. (rods, sleeves, P0021...)
#18
Not mine but an identical car that got the same setup as me dynoed his and made 740 something on a mustang dyno.
#20
[QUOTE=greekc6;4261225]Just had the p0021 code come up on mine. Reason for doing my rods and cams ]
Yes you'd better do the whole engine if you swap the cams, I just did them and they add real power. (My stock rods bent last year with the stock cams)
I would say the engine works now @1,35Bar as @1,5 with the stock cams, and you will need more fuel as well on the whole powerband. (more air, more fuel)
Exciting project!
Yes you'd better do the whole engine if you swap the cams, I just did them and they add real power. (My stock rods bent last year with the stock cams)
I would say the engine works now @1,35Bar as @1,5 with the stock cams, and you will need more fuel as well on the whole powerband. (more air, more fuel)
Exciting project!
#23
Lol, yes their website is ridiculous! But I'm not anxious with that, my car is a blast for street use and Todd's support and knowledge are perfect.
Thread
Thread Starter
Forum
Replies
Last Post
dominik...
996 Turbo / GT2
11
08-09-2010 11:17 AM