Hey guys.

I back into a parking space and destroyed my tech art rear valence. Going back to stock until a new one is built / shipped / painted. Can I take off the old one and put on the new one without removing the rear bumper?

Is there a "how to" out there? Did lots of searching and did not see one...

Thanks in advance. Always painful to hear fiberglass being destroyed.

 

i had to remove my lower valence to install the tech art one and it was near impossible without removing the bumper. I would recommend removing the whole bumper to do so as it's much much easier.

Some good info here: https://www.6speedonline.com/forums/...p-removal.html