Intro - TiKORE - Titanium Lug Bolts
Thread Starter
|
Basic Sponsor
Joined: Nov 2010
Posts: 1,954
From: Miami, FL
Rep Power: 0
Registered User
Joined: Nov 2009
Posts: 589
From: New Jersey
Rep Power: 52
Since this is often a technical forum I have to ask, what is the rationale behind using 6/4 Ti versus 3/2.5. I, but perhaps not others, know the properties of each; I'm just curious if the stresses on the bolts warrant 6/4 or if you prefer the slight weight savings, or maybe you just have a really good arrangement for obtaining 6/4 ingots. Whatever the case, I agree with the above, they are beautiful and sadly I couldn't use them even if you gave them to me (CL wheels)!
Reminds me of a QA course I struggled with in grad school. There was a kid in the class who asked questions routinely that not only didn't I understand (that was bad enough) but in a thousand years I wouldn't have known to ask.
Made me question my very existence (or at least my chances of ever passing that course with the B I needed to get my MBA).
Bottom line....massive curve...I got the B I needed! Always hated that kid though!
Hope all is well with you my friend!
Best,
Tom
Thread Starter
|
Basic Sponsor
Joined: Nov 2010
Posts: 1,954
From: Miami, FL
Rep Power: 0
