Carwash broke my 'S' - replacement?
I disagree. Hairdryer and dental floss to remove the remains of the old. Clean up the surface to remove the goo. Measure a few times and use painter's masking tape to create your centering boundaries - basically a box within which you will paste the decal. Then apply the new lettering. The lettering is already "pre-spaced" on the backing, so you just need to get the overall placement correct.
Thread
Thread Starter
Forum
Replies
Last Post
vividracing
991
6
Jun 10, 2017 07:45 PM




. In any case it is a level II DIY job at worst.

