Werks1 Carbon Fiber Plenum + GT3 Throttle Body for 997.1TT
#1
Werks1 Carbon Fiber Plenum + GT3 Throttle Body for 997.1TT
Category: Accessories
Price: $1000
Private or Vendor Listing: Private Listing
Part fits: Porsche 911 997 Turbo
Location (State): CA
Item Condition: Used
Shipping Information: Item can be shipped
This is a DIY project if you're somewhat adept even though it is quite tight in there. I found the key is to remove the oil filler tube.
Paypal only and free shipping within CONUS, anywhere else you handle shipping.
#3
To install you'll need a check valve and maybe some extra vacuum line and hose clamps just in case. The check valve is built into the stock plenum but external to the Werks. I left it in the car because it was such a pain to remove. It is very tight in there.
I have EVOMSit tune and no CEL. Poke around this forum for people's take on gains. I think most improvement is in mid to full throttle where the engine can breathe better.
I have EVOMSit tune and no CEL. Poke around this forum for people's take on gains. I think most improvement is in mid to full throttle where the engine can breathe better.
#5
p.s if the plenum gives me a hard time ,is it possible to use just the GT3 Throttle body ? what makes the plenum special it is larger ? sorry for the questions but usually i like to get full detail prior ...
Thread
Thread Starter
Forum
Replies
Last Post