Hi,
From auto scan the computer cannot access to module #34 Level Control
On the other hand by using "Select Control Module" I can access to it.
Here attached is the result of auto scan.

I would like to solve this and give a chance to calibrate suspension ride height
Presently I cannot.


This is the error that I have while waiting error while waiting to signal to input the first height value


Best regards

 

Hello folks,

I also noticed that the following modules was not accessible from autoscan (tomorrow I will try each of them individually and report):
Address 06: Seat Mem. Pass Labels: None
Address 07: Control Head Labels: 3D0-035-00x-07.lbl
Address 08: Auto HVAC Labels: 3W7-907-040.clb
Address 09: Cent. Elect. Labels: 3D0-937-049-V1.clb
Address 15: Airbags Labels: 3D0-909-601.lbl
Address 16: Steering wheel Labels: 3D0-953-549.lbl
Address 34: Level Control Labels: 3Wx-907-553-34.clb
Address 36: Seat Mem. Drvr Labels: None
Address 37: Navigation Labels: None
Address 65: Tire Pressure Labels: None
Address 68: Wiper Electr. Labels: 3Wx-955-023.clb
Address 71: Battery Charger Labels: 3D0-915-181.lbl
Address 76: Park Assist Labels: Redir Fail!
Address 77: Telephone Labels: None

Can anyone of them (other that #34) play a role in the calibration of suspension ride height

Regards

 

Following CLOSELY as I am having almost the exact problem. I really need to access the individual struts and add different amounts of air to each before I calibrate.
I am probably going to have to call customer service and have them walk me through it.