I have a new set of Hyperboosts I want to throw in and have no idea where to start any help is greatly appreciated in advance.

-Suman

 

you need to remove the front wheel well liners and remove the intercooler cover. The one on the passenger side is relatively easy. The driver side rates about 9 on a scale of 10 in difficulty. You will need a flexible wire spring clamp remover. It is located behind the intercooler hose on the DS and that has to be removed. Not an issue on PS. Unless you are very mechanically inclined and have the proper tool for the driver side DV, I would recommend having it professionally done. I know, I put the hyperboosts into my CT and the DS was a real *****.

Here's the tool you will need in order to access the hose clamps on the DS. Simple needle nose pliers work on the PS since clearence is not an issue where it's located.

http://www.amazon.com/Mayhew-28650-S.../dp/B0000T4UI4

 

send me a pm with your email and I will send you the guide someone put together that helped me. It does not show use of the special tool for the DS clamps...after 8 hours of frustration, I bought the tool. You also have to remove the bottom pan on the truck to access the DS divertor. It really cannot be accessed from the side like the PS one can...

I tried to upload the word doc, but it's apparently not working right now...

 

how did the install go ? How do you like them ? I noticed a decrease in lag after installing them. Plus they will last the life of the truck, unlike the stockers, potentially.