cayenne 958 water into engine oil and "check coolant level" and water drain
cayenne 958 water into engine oil and "check coolant level" and water drain
Hi everyone,
My cayenne S 2011 is loosing water ... that's is not the issue ...
I drive it from highway for about 3 KM after temperature raising from 90 to highest level in less then 3 seconds... I keep engine on for less than 35 seconds.
Small quantity of water mixed with engine oil (I guess less then 250 ML of water) and that's is the main issue
Is changing of engine oil and filter enough or Do I need to open the engine and make a turning for cylinders head at lathe shop ?
Is anyone had this experience, I need your help please.
best regards
My cayenne S 2011 is loosing water ... that's is not the issue ...
I drive it from highway for about 3 KM after temperature raising from 90 to highest level in less then 3 seconds... I keep engine on for less than 35 seconds.
Small quantity of water mixed with engine oil (I guess less then 250 ML of water) and that's is the main issue
Is changing of engine oil and filter enough or Do I need to open the engine and make a turning for cylinders head at lathe shop ?
Is anyone had this experience, I need your help please.
best regards
Hi everyone,
My cayenne S 2011 is loosing water ... that's is not the issue ...
I drive it from highway for about 3 KM after temperature raising from 90 to highest level in less then 3 seconds... I keep engine on for less than 35 seconds.
Small quantity of water mixed with engine oil (I guess less then 250 ML of water) and that's is the main issue
Is changing of engine oil and filter enough or Do I need to open the engine and make a turning for cylinders head at lathe shop ?
Is anyone had this experience, I need your help please.
best regards
My cayenne S 2011 is loosing water ... that's is not the issue ...
I drive it from highway for about 3 KM after temperature raising from 90 to highest level in less then 3 seconds... I keep engine on for less than 35 seconds.
Small quantity of water mixed with engine oil (I guess less then 250 ML of water) and that's is the main issue
Is changing of engine oil and filter enough or Do I need to open the engine and make a turning for cylinders head at lathe shop ?
Is anyone had this experience, I need your help please.
best regards
I want to clarify that I had add a water coolant a couple of times and warning gone and come back again after water drain ... drain problem solved ... I'm just afraid about engine
Thread
Thread Starter
Forum
Replies
Last Post




