need some help from you guys, i need some parts for my car and my dealership is telling me that they can not order this parts and they don't have the program for installing or reparing this problem *** IT'S ONLY A SEAL !!! ***

what do you think guys ?

this is the torque converter or something like this ( i don't know how is in english )

 

The snap ring should be available anywhere, the gasket from Porsche. I would try another dealer if possible. If they can't take that apart I would not trust them to change my oil.......

 

not the snap rings are my problem, i need the big seal !

 

They need to look at a different diagram- the page you have shown only details a few pieces. There will be a different part/diagram which shows the cases/gasket...

 

there is not any more page about this part ! they said that this part is not for sale and that i need to buy a new gearbox

 

anyone else ???

 

Hey Alex,

I looked all over the catalog, asked our head Motorsports guy, and our two service advisers, and believe it or not, you actually cannot get that seal and gasket separately. We've had to order an entire new transmission before because of that seal.

Crazy Porsche, I know....

 

yes i know that, they are crazy 15.000euro for a seal...

i will make it but i was hopping that in the US somebody made this seal but i see that i don't have luck, thank you very much !!

 

hey Alex have a look into this link from ebay it looks like the seal u r looking for but its for older model .i dont know if its for manual or tiptronic either so if its the same seal contact them maybe they have same thing for ur model
http://cgi.ebay.com/ebaymotors/Porsche-G64-G50-6-Speed-Transmission-Kit_W0QQcmdZViewItemQQ_trksidZp1638Q2em118Q2el1247 QQcategoryZ6755QQihZ017QQitemZ270202297740QQrdZ1QQ sspagenameZWD1V#ebayphotohosting

Salut

 

OK if i were desperate I would make my own, nothing like MR gasket maker..No wounder Porsche is the the most profitable auto MFG

 

maybe good or maybe not, i will show to the porsche guys they must know ( i hope ) thank you for the link !

multumesc frumos !
( roman ? )

 

more details please !

 

I think super putty would do the trick.

 

Its a thick liquid you place it on one side and marry the two parts, its similar to silicon.It takes a while to dry and easy to remove if need be.

 

Hi all.
I am in need of these gaskets as well. using sealant is not an easy solution because the preload on 2 of the 3 bearings in the transfer case will be affected as they are tapered rollers. the last transaxle i pulled apart had a split gasket already and i may need to make one. or i can measure the thickness and remove shims from the bearing stacks.
i have exhausted the mercedes side of the parts spectrum and we do not use gaskets- only sealant in our 4-matic apps.