I am running the OEM Sport Techno wheels, I want to install some spacers when I get a new set of rubber in the near future. What size should I go with and where can I get a reasonably priced set? I remember somebody with the same wheels saying 15mm all around, but I searched and searched and cannot find that old thread. Thanks!

 

Anyone?

 

My car came with Techno wheels; I just measured them and the spacers are 17mm hubcentric type (only rear, no spacer up front) Those spacers didn't work with my HREs; I bought 15mm non-hubcentric type for them.

 

i have them as well and mine are the same as MY996TT - 17mm, with no spacer necessary for the fronts

 

Use a 15mm spacer up front or your cars going to look like a funny car with the wide rear tires and fronts tucked way in the fenders. When i had my stock wheels, i first bought 15mm spacers for rear only and then after putting them on it is very obvious you need them in the front as well.

 

I have 15mm in the back and 7mm in the front with my HRE's.

 

Mike, what are the widths and offsets on your HREs?

 

I recall being told by the guy I bought them from that they were custom made for the Pcar, so they are stock widths and likely stock offsets.

 

Both the wheels I have bought (first HREs and then now OZs) I was told the same thing.

But my HREs were 11.5 in the rear and the OZs are 12 so the offsets are not likely the same. I may be adding some spacers in the rear now that my new tires are beefier.

 

Take a wheel off and check the reverse face, the size and offset should be stamped/cast into them