So hopefully next week I will be installing Ray's Carbon Rotec Seats, I have done a GT3 seat install before so am aware of the battery disconnect etc and seat belt wiring but where should I connect the heated seat pads wires to ensure they work with the OEM seat heating switch ???? Help would be appreciated

 

Wish I could help but that sounds like a question for Rotec Ray...

 

I have done this on a Subaru, so it is different. However it should be really obvious when you remove the factory seat as you will see the cable going from the center console into the seat. I would assume the connector is somewhat universal or easily modified as it will only be 3 wires. Just make sure that when you unbolt the factory seat you don't try to just yank it out. Look underneath for an insulated cable.

 

not quite that simple on a TT as there is a massive junction box under the seat

 

nobody has reinstalled a non OEM heated seat ??

 

Pics?

// André

 

The seats has been installed into Richard's TT. Below are the pics before install;

 

These look really nice. Whats the price on this exact setup with the heating?

 

PM sent!

 

Ray, PM me a price on those also, except gray stitching and suede inserts no cross stitch.

Those seats look amazing

 

Ray, so these seats don't use the factory heated seat button/rocker? How much weight saving for these over the stock heated leather seats?
Thanks

 

pm me for the price too with heating

 

For those that have sat in these......do they sit as low as OE seats (w/OE's in lowest position)?

Thanks in advance.

 

Our sFCGT CF seats is 33lbs each with all sliders/brackets attached. It will be good 45-65lbs saving over a pair of OEM seats. The heated pads are powered by 12V which come with switch. I believe it can be wire up with OEM heated seat button.

 

Thanks Dean, PM sent!

Price quota sent!