Originally Posted by MARKSKI@911tuning

We make each one from scratch. It takes a skilled fabricator along with a JIG to duplicate them. IF you can get them done for $200 Ill pay to supply them to me... Similar ones on the market( from Europe) go for more then twice what I sell them for... I'm not sure what you are complaining about... you should be pointing out those not mine... ( just my opinion).

I could make it hard piping.. I actually have that option too but I discourage clients unless they are skilled mechanics because of the difficulty of the installation.
here are some up close pics...


Here is the hard piping Version.. notice it does not replace the intake on top of motor... the soft version does...

Originally Posted by H8T WP

What i was saying was can i use flexi hopse from the original kit and just fit to the stock intake as shown in the hard-pipe picture! therefore leaving stock intake in place

Thats what will cost me under $200... not the fabrication of the part which isnt used in the hard pipe version...

Originally Posted by MARKSKI@911tuning

Yes you can... You just have to cut the oem intake and weld on a connection piece to slip over the coupler... then connect... no problem...