I Wanted to start one of these because it seems there is quite a few members that have done it. I will be starting in a few days and am always looking for tricks and tips to tough areas and looking for pics. Post away!!!

 

I'm interested in this as well. Would love to have my car wrapped.

 

Few pics of mine.

 

what's wrong with a partial wrap? at least i won't lose it in a parking lot. there's like 100 silver 911's per sq mile out here

 

Here is mine!

 

Did the hood on mine as well 3M 1080 Carbon

 

Now that's what I would've hoped mine would look like. Nice.

 

Here is mine now. Going matte white with a black hood and roof

 

Front bumper the hardest?

 

A few tips I read/learned: Get a good heat gun (harbor freight has a few options for cheap cheap), don't do it in cold weather, start with a big sheet, patience, clean and wax the surface really well, don't watch UTube and think this is easy, by the good film like 3M that is slightly porous allowing the air bubbles out, patience....

Mine is a 3footer and it gets lots of compliments plus it protects, it was a good DIY although not really a novice-one man job. Good luck and looking forward to more pics.

 

Did any of you use 3m primer or sealant? There is some spots and the sharp points that ifeel just won't hold over time. Especially spots that gets dirt and water.

 

This panel sucks

 

These magic clips for the fuel door would NOT come off

 

Any tips for the side vents?

 

I used primer on every piece and edge sealer on the edges.