Jimmy so these will fit a 996T no problem? If thats the case im getting some

 

Yes they do. I will post some pics once they have them installed.

 

Great thanks Jimmy

 

point was, one look at modded y pipes etc and they wont even test the car. they dont discriminate.

 

Didnt you get a 3" Y pipe same as mine a while back Mark

 

That does suck. Must be a PITA. I guess they would run me out the door.

 

dude, its bordering ( can't say "BORDER" ANY MORE LOL ) on insanity out here now.

they literally pay our mufflers more attention than our... ( i wont say it lol )

 

nah, my exhaust is conservative LOL. 2.5 w 200 cel cats w decat pipes.

( whoops! Y PIPE! duh. 5 am coffee deprived lol. no my air box is cut open like the 997turbo just not as purty LOL )

 

This is great!!! Definitely more info on this when its done.

 

Those CF ducts look familiar, a shop in NJ was making some like them - Enzo? Sean at SRM has made some as well but I'm not sure if either he or Enzo is selling them. So long as they seal well game on! I found my stock ducts hadn't been completely sealed on top and tried hard to correct that as I sliced and diced mine, I think it's worth the effort. The duct on the bottom will be slightly odd as the gasket surface moves but it's not hard to solve and the cooler isn't visible. A cast Y-pipe will look closer to stock and with some effort might not be noticed. I wonder if the stock Y could be ported or extrude honed...

 

Enzo Performance in Babylon, NY does make an intercooler setup with a CF inlet shroud, but their intercooler's are 6". This appears to be the complete AMS Intercooler/Intake setup, which includes the IC Cores, CF Shrouds, and the Silicone Inlets. Not sure about the SRM setup, but I do remember seeing something on their Instagram.