multiple install instructions needed!
#1
multiple install instructions needed!
Hey guys, i have been in europe and finally got back to my baby today, i have a mounting list of parts that need to be installed, can someone please point me in te direction of some instructions or give me some....
here is the list of parts i need instructions for:
- front upper center console
- batwing
- 8500 X50 hard wire
- orange cap install
- clear 3rd brake light
any info would be much appreciated! thanks
Shalil
here is the list of parts i need instructions for:
- front upper center console
- batwing
- 8500 X50 hard wire
- orange cap install
- clear 3rd brake light
any info would be much appreciated! thanks
Shalil
#2
The bat wing just pops out...
The upper center console does as well. Take out the accessories first if you have them.
For the hardwire, it depends on your location.
I dont know what the orange cap is and I dont know about the brake light!
The upper center console does as well. Take out the accessories first if you have them.
For the hardwire, it depends on your location.
I dont know what the orange cap is and I dont know about the brake light!
#5
the upper center console, if you are refering to the one with the cassette holder / pocket-
start with the leather covered sides- each side pops off.
grasp your fingers around the rear (edge closest to the footwell) and pull out to the side, when that pops free slide the panel forward.
after you get those off you will see two screws per side under the panels which hold the console in place.
start with the leather covered sides- each side pops off.
grasp your fingers around the rear (edge closest to the footwell) and pull out to the side, when that pops free slide the panel forward.
after you get those off you will see two screws per side under the panels which hold the console in place.
#7
Originally Posted by p0rsch3
last- try over at renntech.org - lots of DIY articles there.
speaking of which- WHY don't we have a DIY section here????
speaking of which- WHY don't we have a DIY section here????
Trending Topics
#10
thanks guys got all of it installed, except the radar detector...still need to figure out how to hard wire that, and then i have to pull the clutch assist spring... and get cracking on the GT3 swaybars!
Thread
Thread Starter
Forum
Replies
Last Post
su_maverick
996 Turbo / GT2
2
08-21-2015 07:14 PM
Fadi
Automotive Parts & Accessories For Sale/Wanted
0
08-21-2015 03:43 AM
vividracing
Boxster / Cayman
0
08-20-2015 12:17 PM