painted rockker panels
#16
$ ?
I keep a eye for them on ebay sometimes there are people that take them from new cars during PDI and put them on ebay.
I paid 150.00 for a box of three last time , I put one on and had the other two sitting after paint to cure before clear film is installed.
Make sure they get primed with bulldog ( primer ) and take the torx screws out of the side mounts and replace with a phillips screw so you can remove easier ( if you carry a small screw driver )if **** happens like me and you need to remove for alignment or to put on a flatbed truck.
Iam going back to stock springs since I go to various different places and iam on my third lip in 14 months
Gee-Bee
I paid 150.00 for a box of three last time , I put one on and had the other two sitting after paint to cure before clear film is installed.
Make sure they get primed with bulldog ( primer ) and take the torx screws out of the side mounts and replace with a phillips screw so you can remove easier ( if you carry a small screw driver )if **** happens like me and you need to remove for alignment or to put on a flatbed truck.
Iam going back to stock springs since I go to various different places and iam on my third lip in 14 months
Gee-Bee
#17
I keep a eye for them on ebay sometimes there are people that take them from new cars during PDI and put them on ebay.
I paid 150.00 for a box of three last time , I put one on and had the other two sitting after paint to cure before clear film is installed.
Make sure they get primed with bulldog ( primer ) and take the torx screws out of the side mounts and replace with a phillips screw so you can remove easier ( if you carry a small screw driver )if **** happens like me and you need to remove for alignment or to put on a flatbed truck.
Iam going back to stock springs since I go to various different places and iam on my third lip in 14 months
Gee-Bee
I paid 150.00 for a box of three last time , I put one on and had the other two sitting after paint to cure before clear film is installed.
Make sure they get primed with bulldog ( primer ) and take the torx screws out of the side mounts and replace with a phillips screw so you can remove easier ( if you carry a small screw driver )if **** happens like me and you need to remove for alignment or to put on a flatbed truck.
Iam going back to stock springs since I go to various different places and iam on my third lip in 14 months
Gee-Bee
#19
Jason or Gee Bee: where could I get a set just like Gee-Bee's front, rear and sides? (same as your sides Jason, didn't know if you have the same front/rear?) Can I order these painted white? Jason, who could do the install for me up here (oh oh, I think I am finally getting ready to start modding....noooooooo!) can you post or pm me with specifics on how and where to order? Are they special parts/number or specs?
#22
? $ parts
Since your up there I would try Suncoast ( Sponsor ) or Carerra Motors Bend OR.
All the parts from the West Coast from the wareouse from Ontario Calif
No Tax in Oregon and there close so frht wont be a factor
Gee-Bee
All the parts from the West Coast from the wareouse from Ontario Calif
No Tax in Oregon and there close so frht wont be a factor
Gee-Bee
#23
Gee-Bee, I recommended that she get her parts from Sunset Porsche since they're down in Oregon. Suncoast is down in Florida so shipping would be considerably higher. I've compared prices between the two and they're comparable. Beats even Carrera Motors too.
#24
thanks for the email Jason my friend - you are the best!
Thread
Thread Starter
Forum
Replies
Last Post
NC 996TT
Automobiles For Sale
13
03-23-2023 06:19 AM