just had 997tt lowered (Champion H&Rs also used their sways). would like to "push" out wheels a little without causing "rub" or changing rims (OEM turbo rims). are OEM 5mm spacers enough all around or go wider? can you do asymmetrical front/rear? can anyone advised width for front/rear for max "look" without causing "rub"? reply greatly needed

 

how far did you drop it?

 

dropped it about 1in maybe 1.5 after settleling front & rear.

 

1.5, wow, that's a lot. Any pix?

 

sorry misspoke probably 1in total after settlement? i am not sure; i went with Champion H&R springs and sways. is OEM 5mm spacers sufficient? different front/rear widths? i have stock turbo rims. please advise

 

i am in the same boat, havent decided yet. I just finished installing techart springs. I have a set of OEM 5 mm spacer kit w/long bolts from my 997 c2, i know they will fit the turbo, had confirmed with sharky.

 

if you go with 5mm OEM spacers please post or send me a PM. thanx. dealer tech advised that 5mm OEM is sufficient and that alot of R&D went into choosing that size with the stock rims.

 

will do. i still need to test drive the car after the spring install. as it has been crapy here in chicago.

 

On a previous post sharky from sharkwerks suggests 7mm front and 15mm rear....

 

what sways did you go with? i did Champion H&R for both; the look greatly improved "less gap" and noticed some improvement in handling; less squat and dive, more stable @ higher speeeds. ride did not get worse maybe a hint more firm. one drawback; will likely bottom out more frequent. you have to take high bumps slow and "sideways"; you'll feel like an idiot