I think it is at least 4 inches without lowering the car. Call suncoast porsche. I think they could tell you the exact measurement.

 

Chris,

Your car is just SICK!

I need to schedule with Cecil ASAP for the TA mods.

 

With 4", have you adjusted the factory ride height settings on the Bilstein PSS? Can you adjust to get higher height?

 

Mine used to be nice and pretty like that...

 

Yes you can! That's why I install with Bilstein PSS. I have my shop (SharkWerks) setup same high as GT3 OEM. I see you have Techart springs, those spring are not as low as the H&R. You should be Ok!

 

The PSS is for my new car with aerokit package, not my current car. I think I must check with the workshop so I get the correct height. How do you measure at the rear, and what height do you have?

 

I dropped my 2005 997 off for the mods

1: gt3 front bumper (thank you to those who suggested this over the lip)
2: techart sideskirts (all my idea)
3: techart springs (slightly softer than the h&r's)
4: Lightly smoke the rear taillights (love it on my blacked out magnum srt8)
5: Repaint My acid stained calipers (hope you guys don't yell)
Did i forget anything? what's a few more thousand after i've gone this far.

 

I tried using your same words and my wife shot me down.

 

Looking good!!

 

R P M in the hizzousse!

 

Back and better then ever ! come check out the new shop.

 

Can someone tell me the distance between the gt3 bumber and the floor,in centimeters (cm)? it`s to know if i can buy the gt3 bumper comparing the distance with my M3 that has 14cm to the floor,and the porsche now has 22cm to the floor.
Thanks you

 

@synergy dood, your car is so clean! good job. so the h&r springs/gt3 combo is really working for you as a dd?