i was told that you can use the power from the side marker by swap the signal to side marker and and then use the steady running light power to power up the led DRL.
after the connection is being swapped. a piwis re-programing would make everything work like a charm

 

hmmmm... can you draw this out for me and email it or PM it. Just visually then I can try with one of my 5 sets

 

i'm not sure if i can draw the diagram, actually all you need to do is use the power from side marker to power up the front led DRL. in this case, there's no front signal light right. so the side marker is the easiest alternate. i dont remember whether a resistor would be needed for this or not, but i think most likely yes. let me see if i can draw something out tonight

 

Just draw your best stick figure layout, snap a photo and email it to me. I can try this out for sure

 

It's been a while... how's the final outcome?
Did it work?!