Gt3 front bumper on my c4s 997.2 ?!
Hi all,
Kindly i need your advice, i've an original front bumper for gt3 997.2 and i need to know if i can install it directly on my c4s 997.2 .. Without anything more than remove and replace .. Plz advice me guys ..
Thanks
Kindly i need your advice, i've an original front bumper for gt3 997.2 and i need to know if i can install it directly on my c4s 997.2 .. Without anything more than remove and replace .. Plz advice me guys ..
Thanks
You'll need to move the wiring harness, headlight washers/ tubes (if applicable), center fill panel (if no 3rd rad) and the velcro tabs for trim by hood release (if new bumper doesn't already have installed). Otherwise, yes it'll bolt right up.
Good luck
PS- you should clean out your condensers/radiators while the bumper is off and I highly recommend installing a set of mesh grilles (if not already on).
Good luck

PS- you should clean out your condensers/radiators while the bumper is off and I highly recommend installing a set of mesh grilles (if not already on).
You'll need to move the wiring harness, headlight washers/ tubes (if applicable), center fill panel (if no 3rd rad) and the velcro tabs for trim by hood release (if new bumper doesn't already have installed). Otherwise, yes it'll bolt right up.
Good luck
PS- you should clean out your condensers/radiators while the bumper is off and I highly recommend installing a set of mesh grilles (if not already on).
Good luck

PS- you should clean out your condensers/radiators while the bumper is off and I highly recommend installing a set of mesh grilles (if not already on).
Are you a potato?
Trending Topics
It will bolt strait on without moving anything as long as it matches your car in regards to headlight cleaners ..
You will need to buy parts though if it is just the plastic skin ...
Wheel arch front liners , radiator scoops , all 4 grills and screws , both plastic shrouds for center radiator and air outlet , and lip spoiler .
Just to make it right without fitting the center radiator .
It looks good once its done though
You will need to buy parts though if it is just the plastic skin ...
Wheel arch front liners , radiator scoops , all 4 grills and screws , both plastic shrouds for center radiator and air outlet , and lip spoiler .
Just to make it right without fitting the center radiator .
It looks good once its done though

Last edited by Ian c2; Jul 29, 2013 at 01:23 PM.
Thread
Thread Starter
Forum
Replies
Last Post
eclip5e
Automobiles For Sale
6
Jul 29, 2019 11:13 AM
vividracing
Nissan GTR
0
Aug 19, 2015 02:11 PM





