Removing PCM instructions
Thread Starter
|
Registered User
Joined: Aug 2005
Posts: 1,096
From: Michigan / Kuwait
Rep Power: 64
Removing PCM instructions
I have been thinking about adding a handsfree kit; does anyone have any instructions on removing pcm or the pins?
I have searched all over; and the only thing I could find where limited instructions (no pictures) on rennteam:
I have searched all over; and the only thing I could find where limited instructions (no pictures) on rennteam:
D694:
Step 1 - Remove small carpeted trim piece from side of center console by PCM (Beside PCM) Using Torx wrench size T-30
Step 2 - Remove two leather side trim pieces using Torx wrench size T-20
Step 3 - Using 5mm Allen wrench turn four (two each side) black hex locks 1/4 - 1/2 turn (CCW, I think) to unlatch side locks. Do not force these. They turn very easily in the correct direction. Open glove box on passenger side to access these latches.
Step 4 - Carefully slide out PCM
Step 1 - Remove small carpeted trim piece from side of center console by PCM (Beside PCM) Using Torx wrench size T-30
Step 2 - Remove two leather side trim pieces using Torx wrench size T-20
Step 3 - Using 5mm Allen wrench turn four (two each side) black hex locks 1/4 - 1/2 turn (CCW, I think) to unlatch side locks. Do not force these. They turn very easily in the correct direction. Open glove box on passenger side to access these latches.
Step 4 - Carefully slide out PCM
Thread Starter
|
Registered User
Joined: Aug 2005
Posts: 1,096
From: Michigan / Kuwait
Rep Power: 64
I am look for a hansfree solution that I can plug the phone into (for charging). Nokia has a fairly priced solution for handsfree/media through their cradle; thinking about getting the kit installed and integrating with PCM/Dension:
http://www.nokiausa.com/accessories/...de:E62,00.html
http://www.nokiausa.com/accessories/...de:E62,00.html
Thread
Thread Starter
Forum
Replies
Last Post
