Picked up a new intercooler heat exchanger
Thread Starter
|
Registered User
Joined: Aug 2010
Posts: 74
From: Marlton NJ
Rep Power: 18
Picked up a new intercooler heat exchanger
So the unit came in and it is installed. The way I installed it made for a VERY tight fit behind the grill. I wanted it positioned so that I did not have to relocate the power steering cooler and keep the original exchanger. I plumbed the new exchanger in series with the old one. There is a flange that hangs down from the metal bumper. I drilled holes and hung the exchanger from it with M8 bolts. I positioned the core so that the petcok is positioned upwards and used as an air bleed. I removed and cut the foam bumper to clear the petcok area. All in all it came out nice. I did not get the chance to datalog the AITs as of yet but I can tell you that the lid feels much cooler for longer after idle time. I will log the AITs tonight at Atco when I run the car. 
Read more at http://www.cadillacforums.com/forums...html?kcplink=1
Read more at http://www.cadillacforums.com/forums...html?kcplink=1
Registered User
Joined: Jul 2010
Posts: 1,229
From: Ocala, FL
Rep Power: 91
Nice setup. I did a dual pass on my GTO over the single that Maggie supplied with the TVS2300. I also upgraded the water tank with a Moroso one that holds more fluid and can be packed with ice at the track.
Thread
Thread Starter
Forum
Replies
Last Post
sdg1871
991 Turbo
77
Sep 12, 2015 06:54 AM
