I have a Vag V202 scanner and I want to know if you can check the temperature of tranny fluid with this scanner and if so how? My mechanic has the capability to change the fluid, filter and gasket but I hear the temperature has to be at a certain temperature. Also how many quarts/liters and types of fluid does the 6HP26A take? All inputs would be appreciated.

 

Service manual says Shell ATF M-1375.4 (Bentley part #: JNV862564A). Note: manual says you must also change the front and centre differential cooling circuit. lubricant oil (Burmah SAF-AG4).

Also note the fluid temperature. Use the VAS 5054A. {navigation} Guided Functions/Component replacement/Select Vehicle System or function/transmission/transmission control/CHECK FLUID LEVEL-TRANSMISSION. The replaced ATF needs to exceed 85C to ensure it fills the cooler circuit.

There are a number of steps required when you change the ATF. If you want full instructions from the IETIS manual, PM me with your email address and I'll provide

 

can the scanner check fluid level?

 

Hey did you ever figure out if the other scanner works?

 

Can you send me the instructions please? I have an 06 Spur with 30,000 miles. Low mileage but 11 years old so not certain to change

 

If you want instructions, please PM me with your email address. Also note: I don't think you need to change the transmission fluid yet.

 

Can you please share to me the instructions? jurgeenh@hotmail.com

 

Instructions were sent via email as per your request.

 

When is it recommended to change the ATF then? Can you please send me the guide. I have sent you PM
thanks

 

please send instructions for fluid change

 

Please send instructions for trans fluid change to tmech48@gmail.com

 

Info sent to provided email.

 

Can you please send instructions for trans fluid change to murali66@yahoo.com