DIY - 958 PCM3.1 Video Interface and Android Module Installation
#16
But the new Capacitive Screen is much better than ours, faster and more accurate.
#18
The sound/fade/balance is still from the original head unit, press the "Car" button, it will switch out of the Android.
#20
All the steering control works, but doesn't change track while in the Android mode. But will work again, once switch out, in the factory interface.
Volume roller, mute, mode, all works.
Last edited by ohnoyuji; 10-11-2016 at 11:02 AM.
#21
Please post a short video of switching between the Porsche interface and the Android interface.
Just curious, what are you plugging into the Video interface if you are using the Android module to watch youtube?
Just curious, what are you plugging into the Video interface if you are using the Android module to watch youtube?
#24
Im ordering the Video and android module today. Are you planning to install yourself? Im in San Jose.
#25
Yes I am planning install by myself, I hope easy to do that.
#27
But I kept the android module.
I have bought an ATSC 20$ Sylvannia tv box. It works! But only stationaary.
If you can find a ATSC-M module, you can hook that on, watch tv while driving (for passenger)
#28
Make sure you pull the CBs (Fuse) of the headunit before you do anything with the headunit and grounding.
The car still feeds power even with car off for a good 15minutes.
When you take out the original headunit out, there are quite a few tabs and screw that you need to open. THey are quite tough, you need to be gentle but also strong finger to do this. Pry using a flat screw driver will work.
And there's two temper proof seal as well. (void factory warranty)
Just becareful when you hook the two new ribbon cable. they are quite fragile I found.
And, ground yourself before you do anything inside the headunit.
I've also succesful installing the backup camera, however, the car original came with a "Solder" on switch, I didn't had the patience to resoldering it.
I left the switch un-operable.
Too bad, I sold the car in August.
But I can provide tips when you guys gets the material.
The car still feeds power even with car off for a good 15minutes.
When you take out the original headunit out, there are quite a few tabs and screw that you need to open. THey are quite tough, you need to be gentle but also strong finger to do this. Pry using a flat screw driver will work.
And there's two temper proof seal as well. (void factory warranty)
Just becareful when you hook the two new ribbon cable. they are quite fragile I found.
And, ground yourself before you do anything inside the headunit.
I've also succesful installing the backup camera, however, the car original came with a "Solder" on switch, I didn't had the patience to resoldering it.
I left the switch un-operable.
Too bad, I sold the car in August.
But I can provide tips when you guys gets the material.
#29
I haven't seen any oem look on aliexpress or ebay before I sold the car.
#30
If I'm streaming music via Bluetooth on the OEM Porsche interface, can I use the Android module for navigation with music at the same time?
Or will the music from my phone cut off?
Or can I stream music via Bluetooth from the Android module and have navigation going on at the same time?
It's so confusing.
Or will the music from my phone cut off?
Or can I stream music via Bluetooth from the Android module and have navigation going on at the same time?
It's so confusing.