Switzer R1KX on the way
Quick update:
Scott's engine went from a table of specially blueprinted components last week to long-block status as of today. Ideally turbos and other components will be mounted later this week and installed in the car soon after that.
From there the break-in procedure will begin as soon as we have a transmission to run the car through, which right now is being built at ShepTrans, fully loaded with Dodson ProMax clutches.
After we break it in properly, dyno-tuning commences, and that is where things will get interesting...
Scott's engine went from a table of specially blueprinted components last week to long-block status as of today. Ideally turbos and other components will be mounted later this week and installed in the car soon after that.
From there the break-in procedure will begin as soon as we have a transmission to run the car through, which right now is being built at ShepTrans, fully loaded with Dodson ProMax clutches.
After we break it in properly, dyno-tuning commences, and that is where things will get interesting...
Good luck, Scott!




