After closer inspection I discovered one of the hoses slipped out from underneath and I was able to fix it up this morning, not visible from the top and i didnt throw any lights either

 

Make sure this is the only issue as it does not explain the on and off and then on again condition. If you blew the hose, you should have been in limp from then on. .6 is limp mode. Sometimes the car can clear this condition by simply restarting the car. By disconnecting the battery, you are clearing active codes (some codes can not be cleared with this approach)...I think this is what you mean by resetting the battery? If you are exceeding 1.3, you could be shutting the TB...and going limp (sounds bad huh?) In any case as Mike says codes will be stored and you should get them read (you do not necessarily get lights when you throw codes!). Good luck.

 

Joel did you get the new map?