Stephen sent out one of his trick units that has been modified to fit into the batwing (very cool btw) and after locating a wiring harness (to hook up to the unused phone connector) from a local boxster owner, my wife got out her crimpers, wire cutters, hair dryer etc.. and went to work on it. The end result is a high quality boost gauge (in PSI woo woo), which upon reflection I have to say reads different to stock. Not only is the stock one laggy but it's off by a couple of PSI here and there. Either way, thanks Stephen.

I'll post some pictures of the finished install (I know Stephen posted some too a while back). Once I pop out the rear panels and run my vacum/boost hoose inside the car as opposed to outside with duct-tape

Once again, I'm not sure if Stephen is going to make many of these but they're very trick.

PS Only thing I didn't do was wire it to the "DIM" (not sure where to tap in anyways) so it stays bright at night as well. To be honest, I prefer it not dim anyways...