Well today i took my new stock sl65
to the dyno..

there were 2 pulls and the second better pull was
708 ft/lb at 2447 RPM
528 rwhp at 4926 Rpm

Unfortunately the car did not let the RPM's go further since the computer onboard wanted to **** to the 5 th gear.. since the break in period has not been achieved yet

this run was done for baseline purposes
so that i can find out how much more power the renntech mods will give me

EVERYBODY AND ESPECIALLY BRITT

THANKS FOR THE PREVIOUS POSTS
I WILL GET THE SAME DESIGN WHEELS IN THE REAR JUST 20x11 SO THAT I CAN FIT MORE RUBBER (LIKE 315's) SINCE THE CAR IS VERY LOOSE FEELING... WITH THE STOCK 285

 

708 ft/lb at 2447 RPM

Wow!

 

What were the hp/tq numbers at the wheel?

 

killer

 

those look like them

 

YES THIS WAS AT THE WHEEL
THE CAR WAS STOCK

AND FRESHLY CALIBRATED DYNO

 

AMAZING!

 

When do you get the Renntech ECU upgrade ? BTW, NICE results.

Also be aware that usually when you get larger wheels you will dyno lower (the wheel inertia is farther out from the center), so the 20" rims will probably take some hp off the dyno #.

 

the renntech should be in 2 weekend from now

and thanks for the 20 inch rimms advise i did not know that

 

KILLER!!!! What a beast!

 

HERE IS THE DYNO SHEET

2 RUNS RECORDED 45 MINS APART THE SECOND RUN WAS STRONGER

 

What's the engine redline?

 

the redline is at 6050

 

B E A U tiful

 

Nice #'s

Any pic's of the Twin SC'd Lambo!?!