I want to get a GT3 front bumper but can someone tell me what's the difference between the GT3 and the GT3RS front bumper ? Is it only the rubber lip on the bottom?

Thanks

 

There's no difference between the actual bumper. The front lip is the only difference with the splitter in the middle.

 

v35's right, you would need to drill the holes for the little rs splitter if you have the regular gt3 lip.

 

gt3 = gt3rs bumper


its actually more then just drilling the holes. there are square notches that need to be cut out if you go that route.

 

so the non rs black lip will fit on the non rs GT3 bumper with no drilling etc?

 

not sure i understand your question if your refering to the bottom lip, there is no drilling involved. it just fastens in place.

 

ok so I just ordered a NON-RS GT3 Bumper from Suncoast, I also order the black rubber lower lip. so the lip just snapped on and off right?? cause I ordered a extra one to replace later on down the road when that one gets trashed.

 

what do you mean by non rs gt3 bumper? both the RS and gt3 have the identical bumper only thing different is the lips they use and both of those are interchangable too.

 

Unless you hit a curb , then it promptly UN-fastens!

 

This is the RS lip on top of GT3 lip. There are 5 hole and nuts to hold the RS lip

 

is there a difference in clearance on either one?