Picked up a set of Cargraphic mesh grills for the GT3 bumper and put them in yesterday. Got them from RSS see link on right (part #CARP97GT3SGRILL)

http://picasaweb.google.com/emailboo...BumperWGrills#

http://picasaweb.google.com/emailboo...79324340469842

http://picasaweb.google.com/emailboo...79627301636002

 

What does that bumper look like without the grill? Is it empty?

 

without grills

http://picasaweb.google.com/emailboo...27636313962306

 

Looks good man, just saw someone posted your car on teamspeed complimenting the look!

 

Very nice touch, I like it! I have the grill in the center of my bumber, but not on the 2 side vents.

 

Looks good, I have been considering the CG inserts for my 997 Stock bumper, how hard were they to install?

 

I wasn't too sure about these when I first saw them but I def. like the way they look on your car!

 

Looks great! I just installed the third radiator over the weekend. I was planning to do some DIY grilles like Daytonaviolet had posted about, but ran out of time. Looks like I will be taking the bumper back off this weekend.

 

Is there a posting that shows the DIY bumper removal, and the third raditor install?

 

The DIY for bumper removal is here: http://forums.rennlist.com/rennforum...ght=screen+diy

I did not find a DIY on the install of the radiator, but it is pretty straight forward. There are two brackets to be installed along with the radiator and 2 hoses. The hardest part I found about the install was plugging in the two hoses without getting coolant all over me I can write a detailed DIY if one is needed.

 

They said that they should sandwich in but they kept getting pushed into the vent. So I used x-small tie wraps and drilled a few small holes to tie the grills to the black inserts that attach to the inside of the front bumper all in all easy. I must say that after taking the front bumper off the first time it's super easy to remove and replace it again.

 

Looks good!

 

Looks great! Nice car.