997 drivers window switch not working - window stuck 1/4 from up
#1
997 drivers window switch not working - window stuck 1/4 from up
Hello!
Need some help. I searched the forums about microswitches however none of the problems were the exact same as what is happening here with mine. (2005 997 C2)
the drivers side window interior switches to not operate either window currently. When using the passenger switch, it raises and lowers the passenger window.
In addition to the driver's side window rocker switches not working for either window, the drivers window does not go up and down and it is stuck in the 1/4" from the top position. It does not move at all when the door is opened or closed.
Any assistance would be much appreciated!!
Thanks!
Brian
Need some help. I searched the forums about microswitches however none of the problems were the exact same as what is happening here with mine. (2005 997 C2)
the drivers side window interior switches to not operate either window currently. When using the passenger switch, it raises and lowers the passenger window.
In addition to the driver's side window rocker switches not working for either window, the drivers window does not go up and down and it is stuck in the 1/4" from the top position. It does not move at all when the door is opened or closed.
Any assistance would be much appreciated!!
Thanks!
Brian
#2
more info
Thanks so much! I have additional info. I now have discovered none of the buttons on that door work. the power mirrors do not work, the power seat does not work.
i had tried to disconnect the battery cable to try to reset. the window ended up going down another inch or more on its own but cannot be controlled by the switches. I think it tried to roll down again when opening the door. now does not move.
all the connections are connected but I will have to open it up again and triple check everything and look at everything closely.
does the control module control everything on that door?
Thanks!
Brian
i had tried to disconnect the battery cable to try to reset. the window ended up going down another inch or more on its own but cannot be controlled by the switches. I think it tried to roll down again when opening the door. now does not move.
all the connections are connected but I will have to open it up again and triple check everything and look at everything closely.
does the control module control everything on that door?
Thanks!
Brian
#5
working now!!
working now!! not sure if the main connector was just not in all the way? I made sure it was pressed in there as well as possible and whah lah!! (main connector into the door motor/control module) thanks for all your help!
Thread
Thread Starter
Forum
Replies
Last Post
r_matt_6
Automobiles For Sale
11
10-08-2015 06:07 PM