Help Needed for Headlamp Adjustment Fault
Thread Starter
|
Registered User
Joined: Jul 2020
Posts: 1
From: NEPA
Rep Power: 0
Help Needed for Headlamp Adjustment Fault
I have a "headlamp adjustment fault" on startup. With my Foxwell NT530 and am able to see through the live data that the left motor position does not changing as I drive. I also see a fault code on the module (8040) which noted "No Signal/Communication- DTC-LN Bus stepper motor, HBA left". The headlamps move both vertically and horizontally when I do the light switch/key position calibration test. I would assume this means that there is either a wiring connection or module issue not the stepper motor.
Has anyone seen this or have any thoughts on how I can find the source of my problem?
Has anyone seen this or have any thoughts on how I can find the source of my problem?
Thread
Thread Starter
Forum
Replies
Last Post
Scrotius
6speed Technical Information forum
9
Dec 14, 2019 09:58 PM