When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I have taking over a 2006 v8 vantage that has not been started sense 2014..
I just got the car running But my dash and all the rest of the electric to the car Is dead and I have a rattle ticking sound from the boxes.
I puta link below of a clip I posted on YouTube.
do any one of you recognise the problem?
did it start under battery power or was it jump started ?
after so many years i would without doubt start the trouble shooting
with a brand new battery..
did it start under battery power or was it jump started ?
after so many years i would without doubt start the trouble shooting
with a brand new battery..
Hi
I bought a new battery. And it started . But dash and radio and lights are dead ..😖
Power supply fault. Disconnect the negative side cable, ensure the key is in hand (not in ign) reconnect battery and cycle battery "on" button at the bottom of battery on the + side. Shut all the doors, hood,hatch. Then lock/unlock with key or remote. Remote FOB may not work due to age of internal battery. Then attempt key in ignition to start.
Is it possible that the light dimmer is all the way down?
Originally Posted by J doubleU
Power supply fault. Disconnect the negative side cable, ensure the key is in hand (not in ign) reconnect battery and cycle battery "on" button at the bottom of battery on the + side. Shut all the doors, hood,hatch. Then lock/unlock with key or remote. Remote FOB may not work due to age of internal battery. Then attempt key in ignition to start.
i got a tip that it could be in crash mode . The car have been in a little accident. Do any one know how to reset the crash mode?
CEM needs programming by a dealer along with keys and remote FOBs. You will likely need new remotes as you need the codes to enable them for reprogramming to new CEM.
I also have a 2006 V8V. I had to replace my CEM a couple of years back. The CEM is a Volvo unit. If you plan on replacing it you will need the car config file from AML in addition to AMDS & the key codes to compete reprogramming. If these are not available to you, you may be able to get it repaired by a Volvo electronics specialist and they can retrieve the car config from the existing module.
I also listened to your video. It actually sounds like you have a sticking relay on the CEM. Try replacing the two relays I'm pointing to in this photo. The second pic is the Volvo part info for the CEM.
06-02-2018, 12:54 AM
