Hey folks- My OEM PPF looked like 'French Crackle" pottery... Really bad. One sections was missing. Tried to fid a place in Dallas I trusted. Took me weeks. I finally found Forecefield Pain Shield/Kevin Williams. Have a nice air-conditioned shop, perfect lift and takes his time (you can't rush genius, right?. Matched the OEM pieces nicely. Looks SO much better. It's also much thinner than the OEM PPF, so you really don't notice it. Very pleased.

New PPF....passanger side

New PPF...drivers side

Old PPF, drivers side, bottom section missing..

Old PPF, bright lighting, passenger side.

Old PPF, passenger side, dim lighting.

 

Man anything's better than that crackle pattern you had going on there!

 

Fore sure... The installer said it was a beating to remove & clean....

 

That looks fantastic.

 

Thank you Ascendant, I appreciate the kind words; yes it’s a tremendous improvement compared to what it was

 

Nice job, will have to look him up and have him take a look at mine, need to get the front protected pretty soon.

 

I had the same pieces replaced on my Rapide. All of the OEM pieces were replaced. The installer did a longer strip on the rocker panel than OEM. Not crazy long or anything. He was also doing a complete PPF on a new black DBX. Looked fantastic.

I also did a strip on the top edge of the rear bumper where it meets the hatch. Prevents scratches from the battery tender cord, and fingers from opening the hatch.

 

Great ideas!