Year: 2003
Make: Ford
Model: Mustang Cobra
Price: $28500
Mileage: 21000
Color: Oxford White
Private or Dealer Listing: Private Listing
Location (State): TX
Transmission: Manual
Drivetrain: Rear Wheel Drive

2003 Cobra
21k miles
Exterior is 9.8 out of 10 (not a single dent or ding)
Interior is 9.5 out of 10 (leather and suede inserts are nearly perfect)

Motor, Fuel, and Underhood Modifications:
*2.2L Kenne Bell Twin Screw Supercharger w/ 18lb and 21lb Pulleys
*Custom KB Intake Port
*Accufab Throttle Body (RWTD Modified)
*JLT Big Boost CAI
*SCT 2600 Billet MAF
*Billetflow Idler Pulleys
*Start n Charge Hi-Output Alternator
*Metco 3.2 Alternator Pulley
*Metco 4lb Lower Crank Pulley
*Kooks Long Tube Headers
*Bassani SS Off Road X-Pipe
*Bassani SS Cat-back w/ 3.5" Chrome Tips
*LDC Cooling Mod
*LDC Freeplay Kit
*LFP "Icebox" Intercooler Reservoir (Black Powdercoat)
*Canton Coolant Expansion Tank (Black Powdercoat)
*LFP Dual Pass Intercooler/Heat Exchanger
*UPR 160 Deg Thermostat
*Ford GT Coil Covers (Super Nice!)
*Fore Billet Fuel Hat
*Twin Ford GT Fuel Pumps (Ford Motorsport)
*8AN Braided Fuel Line (all the way up to the stock rails)
*Fore Billet Fuel Filter (10 Micron)
*Zone 5 MDM JR FPDM Controller (Fuel System Controller)
*Kenne Bell 40amp Boost-a-Pump w/ 8ga Wire Upgrade
*Siemens Flow Matched 60lb Injectors

Suspension and Chassis Modifications:
*UPR Tubular K Member w/ Tubular A Arms
*UPR Front Coilovers (250 Spring Rate)
*Tokico Adjustable Front Struts
*Maximum Motorsports Rear Coilovers (500 Spring Rate)
*Maximum Motorsports Camber/Caster Plates
*Subframe Connectors

Drivetrain Modifications:
*Spec 3+ Clutch
*Fidanza Billet Steel Flywheel
*Lethal Performance Throwout Bearing Retainer Sleeve
*Liberty 26 Spline Input Shaft
*Fiore Billet Firewall Clutch Adjuster w/ Aluminum Quadrant
*MGW Short Throw Shifter w/ Cobra Bob Anti-Rattle Gasket
*MGW Ultra Gripper Shift ****
*Level 5 Halfshafts
*Bruce's Derlin IRS Bushings
*Billetflow IRS Brace
*UPR Driveshaft Loop
*ARP Rear Wheel Studs (Extended)

Brakes and Wheels
*R1 Concepts Cross Drilled/Slotted Rotors (Front and Rear)
*Hawk HP Brake Pads
*Baer 1/2" Billet spacers (Rear) (Wheels/Tires Sit Perfect!)
*FR 500 Wheels (Black Powdercoat)
*17" X 10" Front w/ BFG 275 40 17
*17" X 10.5" Rear w/ Nitto NT05 315 35 17 (Brand New)

Exterior and Interior
*Autometer NV Boost Gauge
*Autometer NV Fuel Pressure Gauge
*AEM Uego Wideband A/F Gauge/Sensor
*Raptor Shift Light (Hidden Behind Center AC Vent)
*Passport Escort Radar Hardwired
*KVS KW-XR610 Head Unit
*Infinity Kappa Component Speaker System
*JL Audio 450/4 Amplifier
*Xtant Batt Capacitor
*5% tint Enery where with Double Limo Rear
*Viper 2 Way Alarm w/ Motion Sensor
*SS Rear Cobra Bumper Inserts
*Fiore Billet Hood Vents (Anodized Black)
*6000K HID Headlights and Fog Lights

Computer and Tuning:
*SCT X Cal 3 (obviously will come with the car with 3 tunes: Street, Aggressive Street and valet)
*N2mb WOT Box

Fluids:
*Royal Purple Fluids Throughout with Fresh Redline Blower Oil
*Engine Oil, Blower Oil and Rear Gear Oil All Fresh With Under 500mi.

I have never run the 21lb pulley. The car made 525rw with ONLY 14 deg of timing. This car will handle up to 19-20 deg and probably make close to 600rw. I had the car tuned super safe because my wife was going to be driving it on a regular basis. I will have my tuner tune the car and provide dyno sheets up to 18-19 deg if timing if you like....with a deposit of course.
I will let the Photos and Mod list speak for themselves. Please contact me through, email, PM, or you can call me.

-Justin 512 six eight nine 0880
*All Trades Considered.

 

Nice car! Good luck with the sale. Very complete mod list, clearly no corners were cut

 

Thanks a bunch. This is probably one of the nicest Terminators for sale in the country right now.

 

nice car

 

Very nice!

Jason