FS: EvoMS 775 VTG's with EvoMS Diverter Valves
FS: EvoMS 65mm "775 kit" VTG's with EvoMS Diverter Valves
Category: Engine - Power Adders
Price: $3500
Private or Vendor Listing: Private Listing
Part fits: Porsche 911 997 Turbo
Location (State): AZ
Item Condition: Used
Shipping Information: Item can be shipped
I made 719awhp and 696tq with these with about 30hp/tq left to go before they're out of breath.
Direct bolt on vs stock setup.
Asking $3500 + shipping for these.
Pictured here in the back
Last edited by dhahlen; Apr 9, 2015 at 04:42 PM.
Registered User
Joined: Oct 2006
Posts: 497
From: Lansdale, PA
Rep Power: 81
I think he was asking size of the wheels like 65mm, 68mm etc.
Trending Topics
Registered User
Joined: May 2010
Posts: 1,601
From: Brampton,Ontario,Canada
Rep Power: 205
What were your supporting mods and type of fuel to hit 719AWHP?
That sounded like a killer street set up man!!
If I am not mistaken, did you bend your rods with this set up?
That alot of low end hitting torque with those VTG's...again must of been a killer streetable machine!!
The key would be to bring and limit the tq gradually in the tune.
That sounded like a killer street set up man!!
If I am not mistaken, did you bend your rods with this set up?
That alot of low end hitting torque with those VTG's...again must of been a killer streetable machine!!
The key would be to bring and limit the tq gradually in the tune.
Hi Bobby,
I did a whole write-up on the kit here:
https://www.6speedonline.com/forums/...ls-inside.html
Note this article was done when I was running 100 octane with 200 cel cats. I switch to E85 and went catless and picked up a little more power.
No bent rods, car is still running great!
They do a decent job, but certain alpha setups can get a lot more low end power. I get boost around 3200rpm and they hit hard at 4000rpm.
Supporting Mods:
EVOMS 775 Kit which includes:
-EvoMS Billet Upgrade 65mm VTG Turbos
-EvoMS Clubsport Intercoolers
-EvoMS Turbo manifolds
-EvoMS Turbo inlets
-EvoMS Boost Hoses
-EvoMS Upgraded BPV
-EvoMS Stage 3 Clutch
-EvoMS 82mm Intake Plenum (IPD)
-EvoMS 80mm Throttle Body (GT3)
-EvoMS Upgraded Coil Packs
-Upgraded Spark Plugs for EvoMS 775 Kit
-BBi Barcode Exhaust w/Cat Delete
-EvoMS Leakproof Kit for Throttle Body/Intake
-COBB 1000cc Injectors
-Cobb Access Port with 91 pump, 100, and e85 tunes (personally tuned by Cobb!)
I did a whole write-up on the kit here:
https://www.6speedonline.com/forums/...ls-inside.html
Note this article was done when I was running 100 octane with 200 cel cats. I switch to E85 and went catless and picked up a little more power.
No bent rods, car is still running great!
They do a decent job, but certain alpha setups can get a lot more low end power. I get boost around 3200rpm and they hit hard at 4000rpm.
Supporting Mods:
EVOMS 775 Kit which includes:
-EvoMS Billet Upgrade 65mm VTG Turbos
-EvoMS Clubsport Intercoolers
-EvoMS Turbo manifolds
-EvoMS Turbo inlets
-EvoMS Boost Hoses
-EvoMS Upgraded BPV
-EvoMS Stage 3 Clutch
-EvoMS 82mm Intake Plenum (IPD)
-EvoMS 80mm Throttle Body (GT3)
-EvoMS Upgraded Coil Packs
-Upgraded Spark Plugs for EvoMS 775 Kit
-BBi Barcode Exhaust w/Cat Delete
-EvoMS Leakproof Kit for Throttle Body/Intake
-COBB 1000cc Injectors
-Cobb Access Port with 91 pump, 100, and e85 tunes (personally tuned by Cobb!)
