Category: Drivetrain
Price: $2000
Private or Vendor Listing: Private Listing
Part fits: Porsche 911 997 Turbo, Porsche 911 996 Turbo
Location (State): FL
Item Condition: Brand New
Shipping Information: Item can be shipped

I purchased all the parts when I upgraded the turbos on my 996 turbo. After pulling the trans, the car already has an upgraded PP, clutch etc. so this setup needs to go.

This is a proven setup by pwdrhound and Kevin at Ultimate Motorwerks. Here is a list of all the included parts:

- Sachs 764 pressure plate
- 964RS lightweight flywheel
- ring gear for starter
- gt3rs 4.0 clutch disc
- guide tube with screws
- new pressure plate bolts
- new flywheel bolts
- pilot bearing
- rear main seal

Only part still needed is the appropriate throwout bearing (94411608001) which will run $160-180. This setup goes for 2400-2500. All the parts are new and never installed. Still in original boxes/packaging. Will ship to the lower 48. 2000/shipped in the lower 48 takes the package. Thanks guys!

Jared

 

Where in Florida? I may be local

 

I'm in Oldsmar, just west of Tampa.

 

Still available and ready to ship.. Somebody has gotta be looking for a killer clutch setup with OEM characteristics

 

Will this fit a 997 GT2>?

 

Assuming this performs better than a regular Sachs 2.5 upgrade with LWFW? What's the horsepower/torque threshold compared to the 2.5?

 

+1 on that question.. ?

 

Sent a couple PM's regarding kit..Is it still available? I am local

 

Bump for a great set up....

I put it on my 997 TT with Guard LSD and its amazing ...

GLWS

 

I have 2 years of hard track use on this set up. Holds 600whp and 670wtq without any issues.

 

Sorry for not updating the thread but the setup was sold in June. Thanks