Does anyone know where i can buy a used/new mulliner shift ****. I dont want to pay over 1K for one : (

 

Call Byron Dantzler at Bentley Beverly Hills in parts. 310-967-7150. Not sure if he has any new/used in stock but he usually has a lot of parts in stock. I got mine from him.

 

They don't cost 1k but around 650 bucks. Sometimes pop up on eBay but very rarely so.

 

Look what the postman dropped off today!

Finally managed to snap one up but can't install yet as its in UK, mate will bring it over next week or so.

Tried pushing down chrome section in gear **** in neutral but didn't move a bit. How hard does one need to push on this trim?

Thanks!

 

use both hands and push down on smaller chrome piece,if you are not going to use it again use a plastic prybar to get it started.

 

Is there any pictures or tutorials of how to replace this ?

 

Have you successfully did the install yet?

 

if you have the CD with the workshop manual it is in there,i have it on my computer and will see if i can load it on here. i have tried to before with little success ,

 

ok i have attached instructions with a picture . hope this helps.

 

By semi automatic mode does it mean tip mode as photo shows it in S mode.

Will try and update once my part arrives from UK.