Trying to disable the TPMS warning light and need a walk-thru on how do do this using a V-Checker V202.

I removed fuse 11, connected the V-Checker, turned the ignition key to first position (engine off) select #19 for Can Bus gateway and get the following screen


If I select #2 Can Bus Mode I get a comms error and cannot proceed any further. If I select # 1 NOT Can Bus Mode I get the following screen



Here I get stuck. If I hit the up or down arrow it goes to the following page:


If I select #2 it shows the TPMS error code. If I select #4 it says fault code erased, but when I turn off and turn back on again the TPMS warning light stays on.

I know a few of you have successfully erased the warning light using the V-Checker so I'm hoping you can walk me through it step by step.

In case you cant see my signature line, the car is a 2007 GT

Thanks for any and all suggestions !