Headlight (driver side) blinking/dipped beam warnings
Thread Starter
|
Registered User
Joined: Mar 2012
Posts: 2,298
From: TX
Rep Power: 123
No dealer involvement or recording needed. Buy some type if ballast, remove old and install new one, and you're done.
If your car is older than 5 years, be very careful when doing this job. Wiring inside headlight becomes very brittle, and insulation flakes off. Then you will h as very all sorts of shorts that will manifest in multiple ways, as well as dead ballast and blown fuses too.
If your car is older than 5 years, be very careful when doing this job. Wiring inside headlight becomes very brittle, and insulation flakes off. Then you will h as very all sorts of shorts that will manifest in multiple ways, as well as dead ballast and blown fuses too.
Registered User
Joined: Jan 2014
Posts: 247
From: Palm Desert, CA
Rep Power: 23
No dealer involvement or recording needed. Buy some type if ballast, remove old and install new one, and you're done.
If your car is older than 5 years, be very careful when doing this job. Wiring inside headlight becomes very brittle, and insulation flakes off. Then you will h as very all sorts of shorts that will manifest in multiple ways, as well as dead ballast and blown fuses too.
If your car is older than 5 years, be very careful when doing this job. Wiring inside headlight becomes very brittle, and insulation flakes off. Then you will h as very all sorts of shorts that will manifest in multiple ways, as well as dead ballast and blown fuses too.
Thread
Thread Starter
Forum
Replies
Last Post
Bestisme
6speed Technical Information forum
0
Aug 9, 2017 07:23 PM
Mang0
Cayenne 955/957
1
Aug 7, 2014 03:29 AM