This photo says it all, owner of this 2005 Silver Carrera GT was not too keen on the clear bra currently on the car. Issues with the film:

1. excessive gaps
2. open areas not fully protected
3. uneven edges
4. heavy orange peel texture on the film


We will be removing the pre-existing paint protection film and have the entire vehicle fully protected with our Signature Custom Application. Edges will be nicely tucked away and out of sight with maximum protection.

More photos to come soon!

 

Yikes. If that was my car I wouldn't have accepted that install.

 

what joke
premier and sammy are the best.
now if they can squeeze me in before i sell the damn cars, that would be nice.
remember i keep cars 2-3 months.

 

+1 Look forward to seeing the after shots. Keep up the good work guys.

 

Give us a call mooty! We will get you in as soon as possible before you sell it.

 

Some more photos of the bad installation:

Heavy orange peel texture and massive stretch marks (from overstretching of the film) created much of the unclearness of this clear bra.








These mirrors were only done partial.





Front bumper is wrapped in 4 total pieces, which makes the paint protection film on the car look like a jigsaw puzzle



Exposed paint



Now it is time to remove the film.






All Off! We will spare the details, but we also found razor cuts left behind from whoever did the previous installation. We had to spend an extra 2 hours polishing them down before the film is to be applied

 

Wow my heart bleeds for you..

 

For those in need of replacing or removing pre-existing paint protection film or clear bra, expect that there may be some leftover adhesive residue. The product we use to remove this residue is Prestige's Adhesive Remover. We have tried countless adhesive removers and this product works the best in dissolving the remnants.

Consumers needing this, you can contact us regarding this. If you are an installer, please contact Prestige Film Technologies directly - 408-657-3880

 

Not surprisingly, the previous installer left out a very important area to be protected - the area directly behind the front tires! We stopped counting after the 20th rock chip on each side. We still wrapped and protected this area so that it will not get any worse from its current condition





The curvature of the Carrera GT makes the clear bra install tough, but manageable for our techs



Full Hood - no more pesky line going across the hood.

 

This infomercial brought to you by Premier. :-)

 

^ while it is an infomercial, i have to say, i have yet to seen anyone as consistent and as good. they aren't cheap for sure, but quality is $$$$$.

 

How long does it take to do a clear bra?

 

Really depends on the amount of coverage. The more the coverage the longer it will take. For this CGT, it took us approximately 5 days to complete because of the disassembly that takes place. On this vehicle like all others, proper torquing is essential in placing the panels back as this is an all carbon fiber body.

 

Door panels removed to access the mirrors for removal





Since the roof of the CGT is removable and typically placed in trunk, it can potentially be scratched over time. This makes it an essential panel to full protect. Having to repaint any panels on the Carrera GT is expensive.

 

Rear quarter panels getting installed: