Just thought I would share some pics...
Worked on Brakes all day today with my wrench man Matt (Big thanks again bro) and after a few minor mods here and there managed to get this 380mm set up with RSR bells to work... was running the Brembo 350's, be good to see the difference.

 

Beautiful Stevo - really fills out the open area of the wheels!

What parts did you use and did you weigh the setup to see if you lost weight with this setup?

 

Looks good Steve! Are those 18inch wheels you're fitting them under?

Mike

 

Thanks... nothing in the weight as the bell is only slightly larger, using the Performance Friction race rotor, it has been custom done though and we had to shave about 1mm from the bottom of the inner caliper... really happy with the results.

 

Yip, Mike 18" CCW

 

Stevo, Was it about 22-24MM in spacing to get them to align with the plane of the rotor edge??

Very impressive!!

Mike

 

Are those standard 6-pot GT3/GT2 calipers with just 1mm shaved? Did you use spacers to shift the calipers farther out?

Nice job...

 

They're definitely 6 piston GT2/3 calipers...

When I did this with 350MM rotors, I didn't have to use a spacer, but I'd suspect Stephen had to use large spacers in spacing out the caliper to meet the rotor...

Mike

 

yes... 15mm shim with stock 6pot

 

Beautiful - thanks guys.

 

Wow, 380mm in 18".
Stevo, have any pic of how you do it? Where to get that shim?

 

Shim custom made by Brembo, 100mm bolts... everything is spot on, taken the whole day just to make sure everything was working correctly.

 

Crikey Steve! They look nice
What rears are you using?

BTW, those wheels and tyres look very nice too

 

Hi Ant... using 350mm Alcons on rear

 

Looking good Stevo , did you get the rears done aswell ? When is the first outing for the car after the winter upgrades.
Thanks alot again for the shot of the lead .