Clutch Kit
#2
Very hard to read. If you are keeping the dual mass flywheel then I would use the gt2 disc ( un sprung) and a 999 pressure plate. The un sprung disc is lighter and will be much easier on your syncros. Also this set up will work for you with all bolt on mods until you up grade fuel injectors.
#4
Very hard to read. If you are keeping the dual mass flywheel then I would use the gt2 disc ( un sprung) and a 999 pressure plate. The un sprung disc is lighter and will be much easier on your syncros. Also this set up will work for you with all bolt on mods until you up grade fuel injectors.
I spoke with Cargraphic, this is what is available. It's hard to get anyone here to install anything other than car specific OEM parts http://www.cargraphic.com/index.php?/s,6,7,18,717,1287,1057/&start=6Single mass Sport
clutch kit / Single Mass
Price: 2.500,00 EUR /5
Last edited by reddswiss; 05-20-2011 at 09:58 AM. Reason: Single Mass
#6
Europe is expensive! Kit includes LWSMFW
#7
If it is the lwsmfw then you will need the throw out bearing with the longer ears (think 944 part) and the sleeve that the throw out bearing rides on, neither in pic. If so then that seems to be the same setup that UMW sells. I am not sure what it is like to import parts but you can save a lot of money. PM in bound!
Trending Topics
#8
Very hard to read. If you are keeping the dual mass flywheel then I would use the gt2 disc ( un sprung) and a 999 pressure plate. The un sprung disc is lighter and will be much easier on your syncros. Also this set up will work for you with all bolt on mods until you up grade fuel injectors.
The GT2 clutch kit is just a 996TT clutch with an un-sprung disk. No increase in torque capabilities.
#9
Hey buddy, you can get the clutch disc and pressure plate from Sachs racing itself at about 1K, and buy a RS flywheel + all the bolts/bearings etc from a Porsche dealer for under 1K.
Total less than 2K €.
These are the parts you need if you use the rs flywheel
931-102-111-00 BALL BEARING
928-102-151-01 SOCKET SCREW
944-116-080-01 RELEASE BEAR
950-116-813-30 CLUTCH GUIDE
964-102-239-31 FLYWHEEL
964-114-143-31 RING GEAR
N-014-715-3 SCKT SCREW
Total less than 2K €.
These are the parts you need if you use the rs flywheel
931-102-111-00 BALL BEARING
928-102-151-01 SOCKET SCREW
944-116-080-01 RELEASE BEAR
950-116-813-30 CLUTCH GUIDE
964-102-239-31 FLYWHEEL
964-114-143-31 RING GEAR
N-014-715-3 SCKT SCREW
#10
HI,,There are 2 different 999 pressure plates....One has more clamping force then the other....There was a recent thread on this.....Also Sachs has a higher performance GT2 disc with special lining over stock one which has more holding power.....Good Luck
Thread
Thread Starter
Forum
Replies
Last Post
eclip5e
Automobiles For Sale
8
04-28-2022 12:38 AM