Looking for some spacers for the Siemens 60 pound injectors. Who has them?

 

Call Markski at 911tuning. He has em

 

Why use that injector? There are better injectors available.

 

http://www.911tuning.com/996-Turbo/F...tors-p-62.html

 

I got them thinking they were what I needed? Should I switch or am I ok?

 

I didnt think the 60s needed them ,,only the 72s ?

 

i have the 72 lb injectors. no spacer needed

 

I believe when I got my 72 injectors from EPL way back when, there were some kind of spacers,,Maybe for the fuel rails now that I think more about it because of the height of those injectors..

 

no spacers at all on mine. got them from epl also. i did open the mount holes in the rail just slightly with a file but that was it. plug and play with the adapters for the connectors.

 

Those injector have been around for quite so time.. Why they where used?

1) They where the largest high impedance injector available.

2) They use the EV1 plug.

The reason people use them is there is plenty of drop in flashes available. You can only make about 775-800 rear wheel with those injectors running high rail psi and no over head left (100% duty). It is safer to run a bigger injector as the ecu will trim 25% +/- to save you engine if need be. There are plenty of high impedance injectors out there to choose from, many need no mods to the rails.

Tim

 

I'm not running more than 600 at the wheels on my 18g setup so I think they will be fine.

 

we use 60s and 80s.. work very well... had only one fail at startup but the shop caught it....

 

Looks good, thanks Markski! I'll see how they fit over the weekend.