as a comparison for a setup very few have complaints about, remember the x73 setup is a 20mm drop. those preset figures and suggested numbers should show vast improvement. occasional scraping is just gonna be part of the joy. angle it as best you can and wtf out for speed bumps! lol its either that, or row row row your boat, gently down the stream.

 

Yup...+1

 

02996ttx50, lol....I'm with you.

I agree though, that even stock height I have scraped...and I'm really careful about that. I think just about 20mm of drop is the sweet spot. I may go just a tad lower though. Hopefully my coilovers get here soon so I can get get rid of my oars and anchor

 

Jimbo I should have my exact heights today if you run what I have u will be very happy. Its well suited to the crappy roads we have down under.

I think the re-bound is set at 3 front and 6 or 7 rear. Best you play with that until ur happy

 

Hah! I hear ya I'm probably near -42.5 rear if not more and my clearance at the front is well let's just say my gf's finger barely fits BTW the... Never mind lol

Scraping is part of life. I'm over it and my most recent c4s lips, is, well I continue to re-shape and trim it! With not much left. @ $250 per lip!? I'll keep "sanding" Hah.

 

Thanks Tim,

I think I read that PSS9 have are opposite stiffness settings, so 9 being softest and 1 stiffest wheres the PSS10 with 10 being stiffest. Or am I wrong?

I know its definitely 10 stiffest on PSS10 as it was stated in the description in my box

I managed to give you reps.

 

Oh I know



Im not done with installing all the bits I have for the car's first go round so it wouldnt do any good to corner balance it now. I will see if I can get a better shot of the car from the side (I like a little forward rake anyway)

 

Yes i think pss9s are opposite to urs so ur rite for the pss10s

My ride heights are 107mm or 108mm at front & 122mm or 123mm on the rear.

 

Cool more reps ill give u some too

 

Thanks Tim
Where are you measuring it to ?

 

Measured from the four factory measuring points waiting to find out where they are but im sure it will say in the manual found on here.

 

Jimbo pm me ur email and ill send u pics of the points the measurements are taken from

 

PM sent
Hope your not going to too much trouble.

 

Always a pleasure to help another 996 turbo brother especially an Aussie one.