creaking after sways were put on
creaking after sways were put on
Hi
I recently put on some H and R sway bars and now I have an annoying low speed creak, especially when slowing down or when going over drive ways. Here's my setup
07 C4S w/ PASM
Bilstein damptronic coilovers
Front and back H and R sway bars at the intermediate setting.
took it back to the installer and they "re-lubed" the sways which helped for about 300 miles.
Now the creaking is back
I recently put on some H and R sway bars and now I have an annoying low speed creak, especially when slowing down or when going over drive ways. Here's my setup
07 C4S w/ PASM
Bilstein damptronic coilovers
Front and back H and R sway bars at the intermediate setting.
took it back to the installer and they "re-lubed" the sways which helped for about 300 miles.
Now the creaking is back
it's normal to have creaking sways especially if they did a poor job lubing the bushing. the installer has to lube the inside of the bushing. take it back again and see if they could remove the bushing to have it re-lubed.
I pretty much have the same set up as you but without any creaks. I don't remember having to do any special lubrication when the sways were installed about a year (~6,000 miles) ago.
According to the marketing spiel from AWE Tuning where I bought mine, "All H&R swaybars use a teflon mesh lined bushing to eliminate squeaking under movement and the need for periodic lubrication. Trust us when we say that this is a terrific idea!" You might want to call H&R directly to discuss. GL,
According to the marketing spiel from AWE Tuning where I bought mine, "All H&R swaybars use a teflon mesh lined bushing to eliminate squeaking under movement and the need for periodic lubrication. Trust us when we say that this is a terrific idea!" You might want to call H&R directly to discuss. GL,
Hi
I recently put on some H and R sway bars and now I have an annoying low speed creak, especially when slowing down or when going over drive ways. Here's my setup
07 C4S w/ PASM
Bilstein damptronic coilovers
Front and back H and R sway bars at the intermediate setting.
took it back to the installer and they "re-lubed" the sways which helped for about 300 miles.
Now the creaking is back
I recently put on some H and R sway bars and now I have an annoying low speed creak, especially when slowing down or when going over drive ways. Here's my setup
07 C4S w/ PASM
Bilstein damptronic coilovers
Front and back H and R sway bars at the intermediate setting.
took it back to the installer and they "re-lubed" the sways which helped for about 300 miles.
Now the creaking is back
Can you have the coilovers looked at?
Trending Topics
coilovers went on first so i'm pretty familiar with all the clunks associated with them. i've tried everything includeing nylotron washers, replacing the strut bearings, etc.
the creaks started after the sways went on so i'm pretty sure it's from that.
the creaks started after the sways went on so i'm pretty sure it's from that.
Thread
Thread Starter
Forum
Replies
Last Post
proTUNING Freaks
997 Turbo / GT2
17
Sep 15, 2015 07:28 AM





