Another offset Question
Another offset Question
Would these work on my 997.2 NB at all?
Stock height (may do H&R springs eventually)
Rear 19", ET31, 11" w/ 295/30
Front 19", ET41, 8.5" w/ 235/35
Stock height (may do H&R springs eventually)
Rear 19", ET31, 11" w/ 295/30
Front 19", ET41, 8.5" w/ 235/35
Registered User
Joined: Jun 2010
Posts: 221
From: SF
Rep Power: 29
front is fine the rear is aggressive. You might need to do tire stretch. Roll fender or shave fender for sure. let's say after market in Okay looking flush(no fender roll needed) is about 21mm tuck in from your spec.
Registered User
Joined: Jun 2010
Posts: 221
From: SF
Rep Power: 29
it is about 21mm closer to fender from this one in the pic. So I would say it might stick out or being really close to fender.
Not impossible. It could be done with stretch tire and camber.
295 won't do the job
.jpg)
Not impossible. It could be done with stretch tire and camber.
295 won't do the job
Registered User
Joined: Apr 2006
Posts: 5,260
From: Austin
Rep Power: 770
OEM rears are ET 67mm correct. If so, your ET 31 will be pushed out 36mm or almost 1.5 inches - way too much in my opinion.
Registered User
Joined: Mar 2010
Posts: 991
From: philippines
Rep Power: 61
Trending Topics
Registered User
Joined: Jun 2010
Posts: 221
From: SF
Rep Power: 29
Do you have photo of you your set up?
Do you need to roll fender for that ?
I'm about to buy spacer ti push my wheels out a little bit.
and I'm doing calculation. 
Registered User
Joined: Jan 2010
Posts: 343
From: Boston
Rep Power: 31
very good catch, sorry about that.
should be:
Front: 19x8.5 ET46 (235/35)
Rear: 19x11, ET36 (295/30)
Registered User
Joined: Jun 2010
Posts: 221
From: SF
Rep Power: 29
But I think OP has narrow body. I'm not sure how much different in NB and WB.
Thread
Thread Starter
Forum
Replies
Last Post
PelicanParts.com
930 Turbo Vendor Classifieds
0
Aug 18, 2015 04:01 PM
PelicanParts.com
964 Turbo
0
Aug 18, 2015 03:56 PM
