Hello all. I am looking for a source of black lug nuts for a buddy's 08 Vantage Roadster.

Thank you!

 

Go to Gorilla's web site

 

We can always powdercoat them for you. Please pm me for assistance.

 

Thanks all. XJRS, do you know the size/thread pitch of them? Went to their site but could not find an Aston in their application guide.

Thanks again.

 

The Vantage wheel studs are a 14x2mm thread pitch. It's actually a pretty unusual pitch, you might have to shop around a bit, but I think that some of the Ford Trucks might use that size.

 

Thanks so much for the info! Just what I was looking for!

 

Stuart is correct with the 14x2. You should be able to find them in a couple lengths, either 1.4/1.6" or 1.9/2.0" in a acorn/conical base with 3/4 or 13/16 hex. If you are using them with factory wheels i'm guessing 13/16 is better. A lot of aftermarket wheels would use a skinnier 3/4".

 

Thanks Curtis. Going to be going on some aftermarket hoops...

 

Nasty when you purchase those lug nuts can you post the model on here if they turn out good. I will have to do a similar purchase sooner or later. thanks

 

Sure will!

 

any luck with those nuts

 

^^^^Hey sorry zambono...I forgot to post up this info after we got them. I have since forgotten what we even used, but will talk to the owner of the car and see if I can go take a look for you.

 

thanks